2008-2010 FORD POWERSTROKE 6.4L REMAN INJECTOR W/ NEW FUEL LINERestore your 6.4L Powerstroke diesel engines performance with this remanufactured fuel injector paired with a brand-new high-pressure fuel line. Each injector is fully rebuilt to OEM specifications and flow-tested to ensure precise fuel delivery. The included fuel line is a critical upgrade Ford requires a new line be used any time an injector is replaced to prevent leaks and maintain proper fuel system pressure.Whats Included in the Kit:(1) Remanufactured 6.4L Fuel Injector (OEM-spec rebuild)(1) Brand-New High-Pressure Injector Fuel LinePre-installed O-rings and sealing washers (if applicable)Ready for installationFeatures and Benefits:Remanufactured to meet or exceed OEM performance standardsIncludes brand-new high-pressure fuel line for a complete replacementEach injector is bench-tested for flow, spray pattern, and resistancePre-installed seals ensure a leak-free installIdeal solution for misfires, hard starts, excessive smoke, or poor MPGSaves time and money over buying injector and line separatelyHelps maintain proper fuel system pressure and prevents contaminationVehicle Compatibility:20082010 Ford F-250 Super Duty 6.4L Powerstroke Diesel20082010 Ford F-350 Super Duty 6.4L Powerstroke Diesel20082010 Ford F-450 / F-550 Super Duty 6.4L Powerstroke DieselFits either driver or passenger side please verify injector location if ordering multiple units.Replacing the high-pressure fuel line is required by Ford when replacing injectors. Reusing old lines risks fuel leaks or injector failure due to improper sealing.Shipping Disclaimer: We ship via USPS, UPS, and FedEx. Carrier selection is based on package size, weight, and destination. Expedited shipping options is available, call to check freight options Orders are processed within 1 business day (MondayFriday). Orders placed on weekends or holidays will be processed on the next business day. Tracking information will be provided once the item ships. Shipping to PO Boxes, APO/FPO may be limited based on carrier restrictions.California Proposition 65 Warning:WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govInjector Type:HEUI (Hydraulic Electronic Unit Injector)Flow Rate:Approximately 200-220cc at 30,000 psiFuel Pressure:Typically operates within a range of 5,000 to 26,000 psiActuation Method:Piezo-electricAs per Ford Expert Service Recommendation, you should always replace your old 6.4l injector fuel lines tubes after you have removed your old units out.Install Specs:Injector hold down bolt initial torque- 18 inch-lbs.Then install the feed line hand tight.Then injector hold down final torque: 28 lb-ft.Then torque feed line nut: 106 inch-lbs.Then tighten feed line nuts +60 degrees to achieve final torque.*ALSO AVAILABLE IN SET OF 8 – REFERENCE SKU# – F64INJT-8
